![]() ![]() Doxygen will put each output format in a separate sub-directory by default. Once doxygen has finished the Destination directory is where to look for the results. ![]() The fields in the Project pane speak for themselves. The wizard only gives the possibility to quickly setup doxygen, for full control one should use the Expert tab. Right pane The wizard's settings pane, in this pane you will find the settings that are available for the selected topic. By clicking on a topic the corresponding settings will appear in the Right pane. The Wizard tab is divided into two panes Left pane The main topics for easy setting up doxygen. Once doxygen finishes, the log can be saved as a text file. The output produced by doxygen is captured and shown in the "Output produced by doxygen" pane. Once doxygen runs you can cancel it by clicking the same button again. Do this by switching to the Run tab, and click the "Run doxygen" button. Once the configuration file is saved and the working directory is set, you can run doxygen based on the selected settings. This is often the root of the source tree and will typically be correctly filled in if the configuration file is stored at this location as well. Since some configuration options may use relative paths, be sure to select a working directory that is root of those paths. This allows doxygen to use the configuration and also allows running doxygen again with the same settings at a later point in time. Switching between these tabs is possible, e.g you could start with the wizard tab and then fine tune some settings by switching to the expert tab.Īfter doxygen is configured you need to save (see: File menu) the configuration as a file to disk. Run tab with this tab it is possible to run doxygen and view the used settings. Expert tab with this tab one gains access to the full set of configuration options. Wizard tab with this tab it is possible to quickly configure the most important settings and leave the rest of the options to their defaults. When doxywizard is started with a configuration file or one is loaded using the open command (see: File menu) the directory of this settings file used as the working directory.Ĭonfigure doxygen using the Wizard and/or Expert tab. Specify the working directory from which doxygen will run In the menu bar the following parts are available: File menu, Settings menu and Help menu. The user interface consists of the following sections: Menu options
0 Comments
Leave a Reply. |